Step 7: Network Setup

1. Disable unused Network adapters [ REQUIRED ]

1. Press Win + R, type ncpa.cpl and click "OK"

2. Remove all unused network adapters (Only 1 Network adapters is active)

2. Disable ALL WAN MINIPORT [ REQUIRED ]

1. Right-click the Windows logo, select Device Manager

2. Click on the Network Adapters and DISABLE ALL WAN MINIPORT!!

3. Change adapter properties [ REQUIRED ]

1. Press Win + R, type ncpa.cpl and click OK

1. Right-click your active connection and click on Properties

2. Configure it as shown below:

1. Click Configure

1. Switch to Advanced and configure the following properties:

Advanced EEE - Disabled
ARP Offload - Disabled
Flow Control - Disabled
IPv4 Checksum Offload - Disabled
Large Send offload v2 (IPv6) - Disabled
Network Address - Not Present
TCP Checksum Offload (IPv6 ) - Disabled
UDP Checksum Offload (IPv6 ) - Disabled

If you don't have some of these options skip them and move on to the next step.

1. RESTART PC

2. Open CMD as ADMINSTRATOR (and type those commands in delay of 30s between each other.)

ipconfig /flushdns
ipconfig /registerdns
ipconfig /release
ipconfig /renew
netsh winsock reset

1. Open CMD as ADMISTRATOR AGAIN (and type those commands in delay of 5s)

arp -d 
netsh interface IP delete arpcache

1. RESTART PC AGAIN